Select Page

Sensoft Multiline Update

 

Download

 

Installation

  • Unzip and run the installer

 

 

Changelog

  • Sensoft Multiline V1.3.2:
    • Corrected an error affecting the Digital Outputs when DO duration is set to "Until end of measurement" or "Until wire good again"
  • Sensoft Multiline V1.3.1:
    • Marker can be nearer, down to about 30 cm behind the sensor
    • Added a warning if the marker is too near for the given wire speed
    • Reliable marker pulse even if the PC lags
  • Sensoft Multiline V1.3:
    • Better marker integration: DO pulses are now synchronized with the defects. Set the marker positions in the Hardware configuration dialog
    • Added a list of all alerts to the spool file. The TDMS file has a new sheet called Alerts with the time and position of all warnings and alarms
    • Better integration with file copying tools (like e.g. DirectoryWatch): Write handle of spool file is now reliably released at the end of the measurement
    • Fault length is now measured if fault clustering is enabled
  • Sensoft Multiline V1.2:
    • Digital outputs and OPC UA reacting faster to alerts
    • Criteria on Position, Velocity, Signal, Rel. diameter, Rel. ovality, Alarm and Warning
    • Admin mode (Ctrl - A): Restricting what operators can do
  • Sensoft Multiline V1.1:
    • LU x, LU y, LU xy and NE xy without OPC UA
    • Profile graph for LU x, LU y, LU xy and NE xy faults (maximize window)
    • Changed key navigation: Press the Right/Left key to go to the next/previous fault, press N and B to go to the next/previous spool
  • Sensoft Multiline V1.0:
    • Double thresholds, e.g.  10 < lump < 20 μm
    • Length criteria (if fault length is measured), e.g.  LU x > 20 μm and length > 2 mm
    • Accepts commands via GUI, Digital Inputs and OPC UA at the same time
    • Supports multiple Sensystem boxes
    • Supports flat wire
    • Key navigation: Press the Right/Left key to go to the next/previous spool. Press the Down/Up key to go to the next/previous line
    • Custom sensors: Use Sensoft to display and store data from other sensors (diameter, spark test). Create criteria for faults and alarms. Data communication is via OPC UA
    • OPC UA support. See Specs and First steps
    • Supervisor mode: See measurements of different measuring PCs on one screen, updated in real-time. To activate add data folders to Settings|Read folders